go top
 中文     English     Russian
Home > Service information > Faq        
We offer introductory answers to frequently asked questions about Oulin Co., and our business terms as following:If you have
questions about our products, please find below a selection of sections, each one containing the answers of frequently asked
questions relating to that section.If you cannot find the answers to your question then send us a mail or give us a call.
Q: How do I clean and maintain my Whirlpool Bath system?
A: There is a simple monthly procedure to follow to keep the plumbing system clean. Set air control knobs to the closed
position. Fill the tub with hot water to at least two inches above the highest jet. Add two tablespoons of low sudsing
automatic dishwasher detergent such as Calgonite or Cascade. Operate whirlpool for 20 minutes. Drain and rinse the water
from the tub. The following month, substitute 1/2 cup of household bleach for the detergent. Alternate these two cleaners
each month.
Q: What products can be used to clean my tub?
A: Most bathroom cleaners can be used on the tub. However, please avoid abrasive cleanser, it could dull the surface. If the tub is slightly scratched, an automobile wax will restore the beautiful shine of the cast acrylic surface.
Q: Can I get more jets in a tub?
A: The following procedure is recommended to remove most deposits and avoid major accumulations inside the system piping. The actual schedule for cleaning will depend on system usage and water quality, but should not exceed 90 days. Step 1: Fill tub to the top of the trim ring on the highest jet with lukewarm water. Step 2: Add 1-cup low-sudsing, automatic dishwasher detergent and run the whirlpool system for 20 minutes. (Body wrap system = 1 complete timer cycle.) Step 3: Drain tub, refill with clean water and operate the system for 20-minutes to rinse (Body wrap system = 1 complete timer cycle).(Rinse thoroughly.) Occasionally sanitize the system by following the cleaning procedure above, but substitute 1-cup of household bleach for the dishwasher detergent. (Rinse very thoroughly.) For best results, keep the following in mind when caring for your plumbing products: ·Never use abrasive materials or abrasive cleaners on the whirlpool trim (jets, air controls, and suction covers) ·Use extreme caution when trying any cleaner, acid or solvent on the whirlpool system trim. Refer to our WHIRLPOOL SYSTEM CARE AND CLEANING for complete details.
Q: How should I clean the trim of my whirlpool?
A: In order not to damage the finish of your whirlpool trim, only use a mild liquid detergent for cleaning followed by a
thorough rinsing.
Q: Why do I need to have an access under my whirlpool?
A: Access is required to the underside of the unit in the event that servicing is needed. This access may be located inside the bathroom or inside an adjoining room or closet.
Q: What are the electrical requirements for whirlpools?
A: The main pump/motor electrical connection consists of a single dedicated line with a 20-amp ground-fault circuit interrupter breaker (GFCI) and a 20-amp receptacle. For a unit with an in-line heater, a separate dedicated line, also with a 20 amp ground-fault circuit interrupter breaker (GFCI) and receptacle is necessary.
Q: Can I use bubble bath in my whirlpool?
A: We do not recommend the use of bubble bath in your whirlpool. The reasoning is simple; a very small amount of bubble
bath can result in a huge column of bubbles when the system is operated. While this will not hurt the system, it does make
for a messy cleanup.
Q: How do I clean and maintain my Whirlpool Bath system?
A: There is a simple monthly procedure to follow to keep the plumbing system clean. Set air control knobs to the closed
position. Fill the tub with hot water to at least two inches above the highest jet. Add two tablespoons of low sudsing
automatic dishwasher detergent such as Calgonite or Cascade. Operate whirlpool for 20 minutes. Drain and rinse the water
from the tub. The following month, substitute 1/2 cup of household bleach for the detergent. Alternate these two cleaners
each month.
Q: How long is the warranty on my whirlpool system?
A: All whirlpool systems and individual unit options carry a two-year limited warranty against manufacturing and material
defects.

Copyright © 2006-2010 Hangzhou Oulin Sanitary ware Co., Ltd.
ADD: Dangshan Town, Xiaoshan Distict, 311225 Hangzhou City, Zhejiang Province, P.R.China.
Tel: 0086 571 83867216 Fax: 0086 571 83867226 E-MAIL: sales@hzoulin.com